Ankom RD Manuel d'utilisateur télécharger pdf (Page 6)

The ANKOM

Dryer should be installed in a vent hood free of dust and excessive moisture.

The ANKOM

power cord must use a grounded receptacle. Hydrolysis leaves small amounts

of HCl in the filter bags even after rinsing. Drying the hydrolyzed samples in the ANKOM

Dryer removes moisture and the remaining HCl (For drying after fiber or crude fat

determinations, a vent hood is not necessary).

1. Plug the power cord into a grounded receptacle.

2. Tighten the Inlet hose clamp with a screwdriver and route to a clean source of air.

Instrument Set Up and Installation

Requirements:

Tools: Flat blade screwdriver

Power: 100-120V 50-60 Hz (domestic) 220V-240 50-60 Hz (int’l)

1 2 3 4 5 6 7 8 9

Pas de commentaire

Ankom RD Manuel d'utilisateur Page 6